I42 I Feature Operations
Lines
;, ,:_
-. :
Inside Line Access (see
also “Intercom Numbers”)
You can use Intercom (inside) lines to make and answer calls
within the Norstar system. Each telephone has its own associated
two, three or four-digit Intercom number, and up to eight Intercom
lines which can be used to contact other Norstar telephones. Make
sure all the people in your office are supplied with a list of Intercom
numbers.
To use inside (Intercom) lines:
If an I/ line is free, the indicator beside the button is
OFF.
1. Press an m line button.
The indicator turns ON.
You hear a dial tone.
2. Dial an inside number using the dialpad.
OR
Press an Inside Autodial button. .
Line Pools
Line Pools allow each telephone to access a collection of outside
lines using Norstar’s Intercom lines, IFeaturem and a Line
Pool Access code, or a programmed ( button.
For further information, see the Line Pools section of this chapter.
Manual Line Selection
Manual Line Selection allows you to select any free or ringing line
and to override Automatic Line Selection. For example, if your
telephone is on Do Not Disturb or Call Forward and you see a line
indicator flashing with an incoming call, you can take the call by
pushing the indicated line button.
You must select an outside line when there is no Prime Line
defined for the telephone.
‘,.F
Multiple Line Buttons
Multiple Line buttons give you immediate access to more than one
line, and allow you to handle and monitor calls easily. These
buttons also have a Call Waiting function when you are on another
call. The indicator beside the line button flashes when a line is
ringing or on hold.
System Coordinator Guide
To Next Page
Loading...
