16 / Norstar Orientation
Other predetermined settings
In addition to Norstar Administration programming, there is another
type of system programming, which is not fully covered in this
::
Guide. This is known as
Configuration
programming.
,‘I
Configuration programming is performed by the Installer of your
Norstar system or your Service Representative, and is not
accessible to System Coordinators. If your system needs changes
to any of the following Configuration settings, call your Installer or
Service Representative.
To find out how your individual system has been configured, you
can use the System Settings feature. This feature allows you to
see all of your system settings without changing any of them. For
more information, see the ‘System Settings” section of the Feature
Operations chapter of this Guide.
While your Installer or Service Representative is programming in
Configuration, you and your co-workers will be unable to program
some of your Norstar features.
Definitions of Configuration settings are provided in the Glossary of
this Guide. Default settings, which appear before the Installer or
Service Representative changes the settings to suit your particular
office needs, are shown in large
bold
letters.
System Coordinator Guide
To Next Page
Loading...
