Norstar M7310 - Feature Operations

91
:
4
Feature Operations
This chapter has been written for you and your co-workers to use
as a reference to how Norstar features operate.
Some Norstar features may not be available in your system
because of the settings assigned in Norstar Configuration or
Administration programming. If a feature is controlled by this
programming, there will be a note telling where in Administration or
Configuration the settings can be changed. This will help you to
know whether you can change the appropriate settings, or whether
you must contact your Installer or Service Representative.
The Norstar system has many more features than any telephone
could have buttons. You can help your co-workers determine
which features they will use frequently and help them p’rogram
these features onto memory buttons. When the Norstar system is
first installed, every telephone will function with pre-programmed
(default) features.
Remember while reading this chapter that “set” is another word for
a telephone.
Before you begin programming memory buttons, you should be
aware of what features are already programmed on your telephone.
The steps below explain how to use the Button Inquiry feature to
determine what each button is programmed to do.
To determine which features are already programmed:
1. Press (ml
2. Press any button. The button’s function will appear on
the display.
.:
I
.i
.: . .
To determine the set number (Intercom number) of a
telephone:
1. Press Imm
2. Press Ilntercoml
The Intercom number, set Name, and port number (for
the Installer’s use only) appear on the display.
system Coordinator Guide