Norstar Orientation / 19
D. Maintenance
1.
2.
3.
4.
5.
6.
System Version
This section allows the Installer to make sure that the
specified components of your system are compatible with
one another.
Port/DN Status
This section allows the Installer to determine what piece
of equipment (for example a Norstar telephone or an
Analog Terminal Adapter) is connected to any given port
in your system, and whether or not the equipment is
compatible with your system. It also allows the Installer to
discover the status of the piece of equipment (for example
busy or idle), and to turn it ON or OFF as required.
Module Status
This section allows the Installer to check the Trunk and
Station Modules connected to your Key Service Unit and
to turn them ON or OFF as required.
Diagnostics
This section allows the Installer to perform various ire-
defined tests to identify problems within your system.
System Test log
This section provides the Installer with a list of the 20
most recent tests which have been performed on your
system or alarm messages which have appeared on the
Alarm Set. This log shows each occurrence of problem
related messages and tests.
System Administration log
This section provides the Installer with a list of the ten
most recent system restarts, Configuration sessions in
which changes were made, and unsuccessful attempts to
enter your system’s Configuration programming.
System Coordinator Guide
i. *
To Next Page
Loading...
