82 / Administration
Notes on Night Service
Night Service can only be turned ON or OFF from the designated
Night Control Phone. To make this easier, you can program the
feature code -ElFI onto a programmable button, and label
the button
) Night Service
1 Instructions for programming features can
be found on each telephone’s individual User Card, or under
“Feature Access” in the Feature Operations chapter of this Guide.
Once the feature is programmed, you can activate Night Service by
pressing only one button.
In order to have your system’s Night Dial Zero Phone work, you
must turn Night Service ON at the regular Dial Zero Phone (by
pressing
mFeaturel/%ll/
or
1 Night Service I).
A Prime Phone can be designated as a Night Ringing Phone if you
wish. The main reason for doing this would be to enable a Prime
Phone to drive the Auxiliary Ringer only when it is in Night Service
mode. .
When Night Service is active, calls will not ring at the Night Ringing
Phone if it is in either Do Not Disturb or Call Forward mode. Do Not
Disturb will cause the calls to ring at an appropriate Prime Phone if
it does not ring on any other telephones in your system; Call
Forward will cause the calls to ring at the specified destination
telephone.
System Coordinator Guide
To Next Page
