Nortek 2GIG GC3e Series - Next Steps; Reset a Zone, Keyfob, or Keypad to the Factory Default Settings

Copyright © 2019 Nortek Security & Control LLC
53
7. Review the voice descriptor.
Keypad <###> Screen—Review Voice Descriptor
Next Steps
You have fi nished programming a keypad. You can now
choose one of these options:
»
To program another keypad, tap Next Keypad
repeat the programming steps for another keypad.
The system keeps track of all your programming
changes and prompts you to permanently save all
your changes as a group when you exit the System
Confi guration menu.
»
To program the next keypad, tap . This
button becomes visible and available only when
programming the last setting for a keypad.
»
To erase all of the settings you just programmed for
the keypad, tap Reset Keypad .
»
To permanently save the settings you just
programmed, tap Return to System Confi guration.
Then tap . At the Confi rm Changes screen,
tap Save.
The following illustration is an example of the Wireless
Zones screen.
Example—Wireless Zones Screen
2. At the Reset Zone message, verify that you are
deleting the desired item. Then tap Reset.
Reset Zone Message
This restores the factory default settings for the specifi ed
zone, keyfob, or keypad.
Reset a Zone, Keyfob, or Keypad to the Factory
Default Settings
When you reset the GC3 Panel to its factory default
settings, the system erases all of the programmed settings
for any of the zones, keyfobs, or keypads controlled by the
system.
To reset zone, keyfob, or keypad to its factory default
setting:
1. At the Wireless Zones, Wired Zones, Keyfobs, or
Keypads screen, tap the trash can icon next to the
desired item.