22 Small form factor pluggable transceivers
Removing an SFP
Remove an SFP to replace it or to commission it elsewhere.
Procedure steps
Step Action
1
Disconnect the network fiber cable from the SFP connector.
2
Affix dust covers over the fiber optic bore and connector.
3
Depending on your SFP model, to release the SFP, press the
locking/extractor mechanism.
Your SFP locking/extractor mechanism can be different than the
models shown.
4
Slide the SFP out of the module SFP slot.
If the SFP does not slide easily from the module slot, use a gentle
side-to-side rocking motion while firmly pulling the SFP from the slot.
5
Store the SFP in a safe place until needed.
ATTENTION
If you discard the SFP, be sure to dispose of it according to all national
laws and regulations.
—End—
Nortel Ethernet Routing Switch 5500 Series
Installation — SFPs
NN47200-302 03.01 Standard
5.1
27 August 2007
Copyright © 2007, Nortel Networks
.
To Next Page
Loading...
