Nortel 5510 - SFP Specifications; SFP Labels

23
SFP specifications
This section provides technical specifications for the supported small form
factor pluggable (SFP) models. Use this information to aid in proper network
design.
The specifications given in this section meet or exceed the applicable IEEE
standards, where they exist.
In these specifications, unless otherwise noted, receiver sensitivity is
defined as the minimum average input optical power for which the receiver
is guaranteed to meet the bit error rate (BER) of 10
-12
.
Navigation
•
"SFP labels" (page 23)
•
"General SFP specifications" (page 24)
•
"1000BASE-T SFP specifications" (page 24)
•
"1000BASE-SX (LC) SFP specifications" (page 25)
•
"1000BASE-SX (MT-RJ) SFP specifications" (page 26)
•
"1000BASE-LX SFP specifications" (page 26)
•
"1000BASE-XD CWDM SFPs" (page 27)
•
"1000BASE-ZX CWDM SFP specifications" (page 28)
•
"1000BASE-BX DDI SFP specifications" (page 28)
SFP labels
The Nortel label on a typical SFP contains a Nortel serial number, a bar
code, a manufacturer’s code, an interface type, and a part number.
Nortel Ethernet Routing Switch 5500 Series
Installation — SFPs
NN47200-302 03.01 Standard
5.1
27 August 2007
Copyright © 2007, Nortel Networks
.