Northstar EXPLORER 550/550i Installation and Operation Manual
24
5-2-3 Editing a waypoint
Editing a waypoint from the chart display
1 In the chart display, move the cursor to the
waypoint to edit.
2 Press
and select Edit.
3 Change the waypoint data (see section 5-2-7).
Select
Save.
Editing a waypoint from the waypoints
display
1 In the waypoints display, press
or to
highlight the waypoint to edit. Press
and select
Edit.
2 Change the waypoint data (see section
5-2-7). Select
Save.
5-2-4 Displaying a waypoint on the chart
This goes to the chart display, and shows the
selected waypoint at the centre of the display.
1 In the waypoints display, press
or
to highlight the waypoint to display. Press
and select Display.
Or, in the Chart display, press , select
Find, then select Waypoints. Select a
waypoint from the list.
2 The EXPLORER switches to the chart display,
with the selected waypoint at the centre of
the chart.
5-2-5 Deleting a waypoint
5-2-6 Deleting all waypoints
1 In the waypoints display and press and select Delete all.
2 Select Yes to confirm.
To change the waypoint data when it is displayed
in a window:
1 Select the data to change.
Press
.
Use the cursor keys to change the data.
Press
.
2 If necessary, repeat the above step to
change other data.
3 Select
Save.
5-2-7 Changing a waypoint’s data
!
WARNING
When a waypoint is deleted from a route,
check that the changed route does not cross
land or dangerous waters.
A waypoint can not be deleted if the boat is
navigating to it or if the waypoint is used in more
than one route. A waypoint that is used in one
route can be deleted.
Deleting a waypoint from the chart display
1 In the chart display, move the cursor to the
waypoint to delete.
2 Press
and select Delete.
3 Select Yes to confirm.
Deleting a waypoint from the waypoints
display
1 In the waypoints display, press
or
to highlight the waypoint to delete. Press
and select Delete.
2 Select Yes to confirm.
To Next Page
Loading...
