Nortrac 82XTC - Page 100

Technical Specifications
94
Item
Unit
Technical Parameters
TD824/TD904
Final transmission,
rear
——
Single planet bevel gear, outer mounted at both
sides of rear axle
Front drive
axle
Transmission shaft
——
Central transmission shaft
Central transmission,
front
——
Spiral bevel gear
Front differential
——
2 planet bevel gears
Final transmission,
front
——
Mono-planet gearing
Running gears
and
undercarriages
Frame assembly
——
Frameless
Front suspension
——
Front shaft
——
Tire pressure
Front wheel
kPa
118.137
Rear wheel
kPa
118.137
Tires
Specification
Standard:
Front/rear wheels
——
11.2-24/16.9-34
Options:
Front/rear wheels
——
11.2-24/18.4-30
12.4-24/16.9-34
Steering system
Mode
——
Front wheel steering
Steering gear
——
Static hydraulic steering
Brake system
Auxiliary brake
——
Static hydraulic pressure, disc, wet
Parking brake
——
Independent Hand brake
Trailer brake
——
Air-brake, air-cut brake
Mode of hydraulic system
——
Open, semi-partition or separate
Hydraulic oil pump
——
CB-F20/CB-F25
Distributor
——
Lubricate
Oil cylinder
Diameter x stroke
mm
110×128(single action)/110×128
(double actions)
Form
——
Single action (semi-partition)/double actions
(separate)
Suspension system
mm
Rear, three points suspension, Cat. II
Upper suspension point: Joint hole x width:
φ25.2×51
Bottom suspension point: Joint hole x width:
φ28.7×45
Working device
Plough depth adjusting modes
——
Common hoister: press adjustable, gear
position regulated, force position mixed
adjustable and floating controlled.
Or force hoister: height adjustable,
floating controlled
Max. lifting power (610mm
behind the suspension point)
kN
≥15(semi-partition)
Or ≥25(separate)