What to do if NSK VarioSurg 3 Medical Equipment irrigation does not stop?
If the irrigation on your NSK Medical Equipment does not stop, check if the mode is set to Auto Cleaning. If so, press the Flow key to stop irrigation. If the issue persists, it may indicate a faulty circuit, requiring service by an Authorized NSK Dealer.
What to do if NSK VarioSurg 3 LCD display does not properly display?
If the LCD display on your NSK Medical Equipment does not properly display, and part of the display is missing, it could be due to overheating. Turn the Main Power OFF to cool down the unit. Also, refer to the Error Code table if an Error Code is displayed. If the problem persists, it may indicate a failure of the LCD display or driving circuit. Turn the Main Power OFF and then ON. If part of initial display is still missing contact your Authorized NSK Dealer.
What to do if NSK Medical Equipment water does not exit, or flow level is low?
If water does not exit or the flow level is low in your NSK Medical Equipment, check the following: 1. Ensure the Foot Control is connected. 2. Verify the Irrigation Tube is connected to both the Irrigation pack and the Handpiece. 3. Confirm the Irrigation Tube is properly mounted to the pump. 4. Make sure the Pump Cover is closed. 5. Check if the Irrigation Tube is broken or leaking; if so, replace it.
Why is NSK Medical Equipment control unit turning ON, Ultrasonic Output is displayed, and beep sound is heard?
If the NSK Medical Equipment control unit turns ON, the Ultrasonic Output is displayed, and a beep sound is heard, it is because the Foot Control is being operated. To prevent accidents, the Handpiece will not work if the Main Power is turned ON while the Foot Control is being operated. Activate the Foot Control again.
General| Frequency | 28 - 32 kHz |
|---|---|
| Max. Pump Flow Rate | 75 mL/min |
| Display | LCD |
| Power Supply | 120V or 230V AC, 50/60 Hz |
| Rotation Speed | Not Applicable |
| Torque | Not Applicable |
| Sterilization | Autoclave at 135°C |
Details the components of the control unit, including the front panel and operation panel.
Explains the purpose of each individual key on the VarioSurg 3 operation panel.
Details the various elements displayed on the control unit's LCD screen.
Describes the buttons and functions of the foot control unit.
Step-by-step guide for connecting the LED handpiece cord to the control unit.
Instructions for connecting the foot control unit to the main control unit.
Steps for connecting the AC power cord to the control unit and a power outlet.
Guides on how to connect and position the irrigation tube in the pump.
How to attach the hanger post for the coolant solution pack to the control unit.
Detailed steps for inserting the irrigation tube from the solution pack to the handpiece.
Instructions for attaching the tube holder to the handpiece cord.
Procedure for securely attaching and detaching the surgical tip using the tip wrench.
Guidance on correctly placing the handpiece on its stand when not in use.
How to verify the coolant flow from the irrigation system before use.
Guide to setting the power output, coolant flow, and illumination intensity.
How to activate the vibrating tip and important usage precautions.
How to save and recall custom settings for different modes and parameters.
Method to adjust the sound volume for system notifications and alerts.
Information on linking the VarioSurg 3 with the NSK Surgic Pro system.
Process to restore the device to its original factory settings.
Steps for performing automatic cleaning of the handpiece and irrigation circuit.
Instructions for cleaning the LED handpiece and its associated cord.
How to clean the glass rod tip on the handpiece using an alcohol swab.
Guidance on cleaning the main control unit and the foot pedal.
Methods for cleaning various other parts of the system.
Recommended procedures and conditions for autoclaving compatible components.
To Next Page
