NU Aqua Efficiency Series - UV System Connections; Connecting UV System Tubing; UV Filter Power Connection; Pre-Power On Notice

Notice: Do not plug reverse osmosis system into wall outlet yet
IN
OUT
POWER CORD
NOTE:
Improperly cut tubing may cause
a leak
NOTE:
Always check each connection
to make sure its secure
UV System Connections
15
1. Connect the 3/8” tubing coming from the leak detector into the INPUT connection on the back of the
reverse osmosis system. Secure the tubing in place with a retaining clip.
2. Connect the 1/4” tubing coming from the drain saddle into the DRAIN connection on the back of the rever-
se osmosis system. Secure the tubing in place with a retaining clip.
3. Connect the 1/4” tubing to the PURE water connection on the back of the reverse osmosis system. Connect
the other end of the 1/4” tubing to the IN connection of the UV Filter. Secure the tubing in place with a
retaining clip
4. Connect the 1/4” tubing to the OUT connection on the UV filter. Connect the other end of the 1/4” tubing
to the reverse osmosis faucet. Secure the tubing in place with a retaining clip.
5. Connect the power cord to your UV filter and plug into wall outlet.
6. Plug the faucet power cord into the FAUCET connection on the back of
the reverse osmosis system.