8
Installation
Feed Water Adapter
1. Locate and turn o the cold water
valve under your sink. Next turn on the
cold water faucet to drain any remai-
ning water in the line
2. Place a towel below your cold water
valve to catch any remaining water in
the line. Loosen the nut on the water
line where it is attached to the valve.
The feed water adapter can be instal-
led in either location A or B as illustra-
ted in the diagram.
3. Wrap the threads of the water valve
and feed water adapter 8-10 times with
teflon tap. using a adjustable wrench
secure the feed water adapter onto the
cold water valve and the water line to
the feed water adapter.
4. Turn the feed water valve to the o
position for the remainder of the instal-
lation process.
5. Insert one end of your 3/8” tubing
into the quick connect fitting on your
feed water adapter. Secure in place
with a retaining clip.
WARNINGS:
Only connect to cold water line.
Hot water will damage your system.
WARNINGS:
Turn the hot water valve o when
installing on a single handed faucet.
1/2” Connection 3/8” Connection Open Closed
Adapter
Adapter
To Next Page
Loading...