EasyManua.ls Logo

NU Aqua Efficiency Series - Limited Product Warranty Details; Warranty Scope and Coverage; Repair and Replacement Policy; Conditions for Warranty Validity

NU Aqua Efficiency Series
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
Limited Product Warranty
SCOPE
NU Aqua Systems takes pride in selling the highest quality reverse osmosis system (“Product”) on the market. As such, NU Aqua
Systems expressly warrants to the original purchaser that, for a period of one (1) years from the date of purchase, the Product
will be reasonably free of defects in materials and workmanship. Within that one (1) year period from the original purchase, NU
Aqua Systems will, at its option, repair or replace the Product without charge, or refund the cost of the Product, if the Product
fails or does not perform as warranted solely due to a manufacturing defect within the warranty period, subject to the
limitations and exclusions set forth in this Limited Product Warranty. This Limited Product Warranty only applies when the
Product is used, stored, handled, fabricated and/or installed in the manner recommended by NU Aqua Systems in the Installa-
tion Instruction & Owner's Manual (“Manual”).
REPAIR OR REPLACEMENT
Repair or replacement during this one (1) year warranty does not include labor charges, freight charges or any other local
charges from third parties other than NU Aqua Systems, unless NU Aqua Systems expressly approves such charges in writing.
During the entire one (1) year warranty, NU Aqua Systems's obligation to repair or replace shall further be limited to repair or
replacement with the styles, models, products, colors, etc. of the Product that are available at the time of the repair or replace-
ment, and shall be limited to the repair or replacement of only the specific Product that fails due to a manufacturing defect.
Any repaired or replaced product shall also remain subject to the original one (1) year warranty from the date of the original
purchase, and any repair or replacement shall not extend the original warranty period in any manner or start a new warranty
period.
CONDITIONS OF VALIDITY OF THIS LIMITED PRODUCT WARRANTY
Even though the Product has extremely high endurance for operating conditions such as pH, maximum TDS, temperature, and
optimum water pressure,
THIS LIMITED PRODUCT WARRANTY SHALL ONLY BE VALID IF:
1. The replaceable filters and membrane are changed and maintained on a regular basis as directed in the
Manual. Moreover, depending on local water input water quality, regular maintenance may need to be increased.
2. The Product is operated within the confines of the following feed water conditions:
Water Pressure: 14.5 - 58 PSI
PH Range:2-11 Max. TDS: 1000 PPM Water Temperature: 41°-100.4° F SDI: 5
Any information or suggestion by NU Aqua Systems with respect to the Product concerning applications, specifications or
compliance with codes and standards is provided solely for your convenient reference and is made without any representation
as to accuracy or suitability. You must verify and test the suitability of any information with respect to the Product for your
specific application.
NON-COVERED DEFECTS
THIS LIMITED PRODUCT WARRANTY DOES NOT COVER DEFECTS CAUSED BY:
1. Improper storage, installation, maintenance, handling, use and/or alterations of the Product, including, but not limited to,
noncompliance with the installation, maintenance and standard operation conditions stated in the Manual and this Limited
Product Warranty.
2. Unreasonable use, unintended use, or misuse of the Product for something other than its intended purpose as a reverse
osmosis system.
3. Use of replacement parts, filters, membranes or other accessories that are not sold or manufactured by NU Aqua Systems
for use with this particular Product.
4. Damage not resulting from manufacturing defects that occur while the Product is in the original purchaser's possession.
5. Installation of the Product with known or visible manufacturing defects at the time of installation.
6. Damage caused by freezing, flood, fire or Act of God.