8 - 54 en-938821/2
Enter the values to be modified (See syntax below). ☞
Value to be modified Syntax
Number of CNC or PLC axes A [value]
Number of spindles B [value]
Number of interpolated axes IS [value]
Number of PLC axes XA [value]
Display of the new values in the page.
Return to the "S/W OPTIONS SETUP" menu. ☞
EXIT
Example : changing the number of PLC axes to 1
Enter "XA 1". ☞
Display of the line:
NUMBER OF PLC ONLY AXES: 1
REMARK It is possible to enter several modification instructions on the same line leaving a
space between them.
8.9.3 Modification of the Memory Sizes
This modification consists in entering the memory sizes mentioned on the customisation grid.
Requirements
"S/W OPTIONS SETUP" menu displayed (See 8.9).
Actions
Select "MEMORY SIZE". ☞
@
2
Display of the "MEMORY SIZES" page.
. . / . . EXIT
MEMORY SIZES
PART PROGRAM STORAGE : 768
PLC PROGRAM STORAGE : 128
(PP,PLC) ? ❚
To Next Page
Loading...
