NUM 1020 M - Page 328

A - 8 en-938821/2
G52: Programming in absolute dimensions with reference to the measurement origin
Z
Y
X
OM
G52
Syntax: N.. [G40] [G90] [G00/G01] G52 X.. Y.. Z.. A.. B.. C.. [F..]
Cancellation: end of block
G53: Cancellation of shifts DAT1 and DAT2
Syntax: N.. G53
Cancellation: G54
G54*: Enabling of shifts DAT1 and DAT2
Syntax: N.. G54
Cancellation: G53
G59: Programme origin shift
Z
Y
X
OP
G59
OP1
Syntax:
N.. [G90/G91] G59 X.. Y.. Z.. U.. V.. W.. A.. B.. C.. [I.. J.. K.. ED..]
Cancellation: cancellation by G59 different X.. Y.. Z..
G70: Inch data input
1Pouces
Inches
Syntax: N.. G70
Cancellation: G71
G71: Metric data input
10 20 30 40
mm
mm
0,2 m
Syntax: N.. G71
Cancellation: G70
G73*: Scaling factor cancel
Syntax: N.. [G40] G73
Cancellation: G74
G74: Scaling factor enable
Z
Y
X
Syntax: N.. [G40] G74
Cancellation: G73