WARNING: Check that Child Restraint is
securely installed before each use.
Using Vehicle Lap/Shoulder Belt
(preferred installation method)
1 - Route vehicle Lap/Shoulder belt through BLUE
Rear Facing Belt Path and buckle vehicle Lap/
Shoulder Belt. Vehicle belt must be routed
under True Tension Door. (1)
Lock vehicle belt (refer to vehicle owner's
manual). Remove all slack from the vehicle belt
system to properly secure this child restraint. (2)
2 Close True Tension Door and replace Seat
Cover and Infant Insert (if used).
Test by pulling on shoulder belt to ensure it is
locked.
To open True Dension Door, unbuckle vehicle belt
and push down slightly on door to release tension.
Check Installation
Seat is in appropriate rear facing recline position.
Seat is securely installed. Hold seat near rear-
facing belt path and move seat side to side, front
to back, and up and down. Seat should move
less than 1 inch.
Tether strap is not used for Rear Facing
Installation and must be secured in storage
location on back of Child Restraint.
Cup Holders may be placed in any position after
installation.
1
2
1
2
44 RAVA instructions 45RAVA instructions
To Next Page
Loading...
