Using Lower Anchor Belt
1
- Remove Lower Anchor Belt from Storage
Compartment (p.28), move along metal rod,
and route through RED Forward Facing Belt
Path.
2 - Lengthen Lower Anchor Belt as necessary (p.28)
and attach to Lower Anchor points in vehicle.
3 - Remove all slack from Lower Anchor Belt by
pulling loop at end of Belt straight back from
Latch Connector. Close True Tension Door and
replace Seat Cover.
4 - Attach Tether Hook to Tether Anchor on vehicle
and tighten (p.36). Tuck excess webbing
behind Child Restraint.
To open True Dension Door, unbuckle vehicle belt
and push down slightly on door to release tension.
Check Installation
Seat is in appropriate forward facing recline
position.
Seat is securely installed. Hold seat near
forward facing Belt Path and move seat side
to side, front to back, and up and down. Seat
should move less than 1 inch.
Tether is properly used and attached to vehicle
Tether Anchor.
WARNING: Do not install by this method for
a child weighing more than 40 lbs (18.1 kg).
4
1
2
3
54 RAVA instructions 55RAVA instructions
WARNING: Check that Child Restraint is
securely installed before each use.
To Next Page
Loading...
