Using Vehicle Lap Belt
1 - Route vehicle Lap Belt through RED Forward-
Facing Belt Path and buckle vehicle Lap belt.
2 - Remove all slack from vehicle Lap Belt. (1)
Close True Tension Door and replace Seat Cover.
3 - Attach Tether Hook to Tether Anchor on vehicle
and tighten (p.36). Tuck excess webbing
behind Child Restraint.
To open True Dension Door, unbuckle vehicle belt
and push down slightly on door to release tension.
Check Installation
Seat is in appropriate forward facing recline
position.
Seat is securely installed. Hold seat near
forward facing Belt Path and move seat side
to side, front to back, and up and down. Seat
should move less than 1 inch.
Tether is properly used and attached to vehicle
Tether Anchor.
WARNING: Check that Child Restraint is
securely installed before each use.
1
2
3
56 RAVA instructions 57RAVA instructions
To Next Page
Loading...
