1
2
Using Vehicle Lap/Shoulder Belt
(preferred installation method)
1 - Route vehicle Lap/Shoulder belt through RED
Forward Facing Belt Path and buckle vehicle
Lap/Shoulder Belt.
2 - Lock vehicle belt (refer to vehicle owner's
manual). Remove all slack from the vehicle belt
system to properly secure this child restraint. (1)
Close True Tension Door and replace Seat Cover.
Test by pulling on shoulder belt to ensure it is
locked.
3 - Attach Tether Hook to Tether Anchor on vehicle
and tighten (p.36).
4 - Tuck excess webbing behind Child Restraint.
To open True Dension Door, unbuckle vehicle belt
and push down slightly on door to release tension.
Check Installation
Seat is in appropriate forward facing recline
position.
Seat is securely installed. Hold seat near
forward facing Belt Path and move seat side
to side, front to back, and up and down. Seat
should move less than 1 inch.
Tether is properly used and attached to vehicle
Tether Anchor.
WARNING: Check that Child Restraint is
securely installed before each use.
1
2
3
4
52 RAVA instructions 53RAVA instructions
To Next Page
Loading...
