Using Lower Anchor Belt
1
- Remove Lower Anchor Belt from Storage
Compartment (p.28) and route through BLUE
Rear Facing Belt Path under Cup Holder.
2 - Lengthen Lower Anchor Belt as necessary (p.28)
and attach to Lower Anchor points in vehicle.
3 - Remove all slack from Lower Anchor Belt by
pulling loop at end of Belt.
4 - Close True Tension Door and replace Seat
Cover and Infant Insert (if used). Pull crotch
belt through slot.
To open True Dension Door, unbuckle vehicle belt
and push down slightly on door to release tension.
Check Installation
Seat is in appropriate rear facing recline
position.
Seat is securely installed. Hold seat near rear-
facing belt path and move seat side to side, front
to back, and up and down. Seat should move
less than 1 inch.
Tether strap is not used for Rear Facing
Installation and must be secured in storage
location on back of Child Restraint.
Cup Holders may be placed in any position after
installation.
WARNING: Do not install by this method for
a child weighing more than 35 lbs (15.8 kg).
WARNING: Check that Child Restraint is
securely installed before each use.
1
2
3
4
46 RAVA instructions 47RAVA instructions
To Next Page
Loading...
