Operating Instruction and Documentation
MCS 7500 Flex (Bluetooth)
- 15 -
• Observe the wheel position in the MCS (see pic. 5 and 6).
• Place the columns shown in pic. below. Take care, that the antennas are inside of
vehicle area (antennas between vehicles axles; therefore 2 right columns and 2 left
columns.); necessary to improve the radio connection quality.
Before lifting the load, lower the mobile-column-lift (pull the lever slowly) in the lowest
position, otherwise a malfunction can lead it to damages.
• Check the dangerous places of the lift and be sure that there are no objects or people in
the immediate area of the lift or on the lift.
• Switch on the control system; Switch-on all the main switch on position ”1”.
• Raise the vehicle with the mode „Synchronous“. Press the button „lifting“ (Synchronous)
at the operating unit.
pic 7: Synchronous „lifting“
• Lift the vehicle on the working height. Press the button „lifting“ .
• In the display each MCS you can read the momentary height of the supports.
• Observe the complete process.
Wrong
Correct
To Next Page
Loading...
