EasyManua.ls Logo

Nussbaum MCS 7500 - Table of Contents

Nussbaum MCS 7500
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating Instruction and Documentation
MCS 7500 Flex (Bluetooth)
- 2 -
Contents
Foreword ................................................................................................................. 3
Record of handing over ........................................................................................... 5
1.Introduction.............................................................................................................. 6
1.1 Installation and check of the automotive lift ....................................................... 6
1.2 Information of Warning ...................................................................................... 6
2.Master document..................................................................................................... 7
2.1 Lift–manufacturer............................................................................................... 7
2.2 Application......................................................................................................... 7
2.3 Changes at the construction.............................................................................. 7
2.4 Declaration of conformity................................................................................... 8
3.Technical Information .............................................................................................. 9
3.1 Technical ratings ............................................................................................... 9
3.2 Safety device..................................................................................................... 9
4.Safety regulations.................................................................................................. 12
5.Operating instructions............................................................................................ 12
5.1 Positioning of the columns............................................................................... 12
5.2 Putting into operation....................................................................................... 13
5.3 Lifting the vehicle (mode synchronous) ........................................................... 14
5.4 Lowering the vehicle (mode synchronous) ...................................................... 16
5.5 Single-Mode „Lifting“........................................................................................ 16
5.6 Single-Mode „Lowering“................................................................................... 18
5.7 Axle-mode ....................................................................................................... 18
5.8 The key-operated switch function.................................................................... 20
5.9 Equalisation of the MCS .................................................................................. 20
6.Troubleshooting..................................................................................................... 21
6.1 Lowering on a obstacle.................................................................................... 21
6.1.1 Remove the obstacle................................................................................. 21
6.2 Emergency lowering ........................................................................................ 21
6.2.1 Procedure of the emergency lowering ....................................................... 22
6.3 Reset the MCS after an emergency lowering .................................................. 23
7.Inspection and Maintenance.................................................................................. 24
7.1 Maintenance plan of the MCS ......................................................................... 24
7.2 Cleaning of the MCS........................................................................................ 25
8.Security check ....................................................................................................... 26
9.Handing over and Initiation.................................................................................... 26
9.1 Regulations...................................................................................................... 26
9.2 Initiation ........................................................................................................... 26
9.3 Position of the columns.................................................................................... 27
First security check before installation................................................................... 28
Regular security check and Maintenance.............................................................. 29
Extraordinary security check.................................................................................. 37
Hydraulic diagram drawing .................................................................................... 38
Electrical diagram drawing..................................................................................... 40

Related product manuals