Operating Instruction and Documentation
MCS 7500 Flex (Bluetooth)
- 20 -
• Check the dangerous places of the lift and be sure that there are no objects or people in
the immediate area of the lift or on the lift.
• Lower the axle on the working height or the lowest position.
Press both buttons “lowering” at one operating unit of MCS, at you are standing. The
MCS raises a little bit (unlocking the safety device), before the lowering starts.
• Raise the vehicle on the working height.
• Observe the complete process.
• Raise the axle on the working height.
Press both buttons “lifting” at one operating unit of MCS, at you are standing.
5.8 The key-operated switch function
It is only allowed to use the service key through the customer service or the assigned
personnel otherwise danger consists for damages and damages for body and lives.
• The key-operated switch at the operating-column (master-column), is to be used only with
disturbance. Put the key in the key-operated switch if the red light shines (disturbance)
and turn the key on position „1“ . The current error message is ignored by this measure.
Press now the button „lowering“ (synchronous) at one operating unit. The MCS starts to
lower.
Observe the complet lowering process. Check the dangerous places of the lift and be
sure that there are no objects or people in the immediate area of the lift or on the lift.
It is only allowed to use the service key with a disturbance. If the disturbance is
remedied, the key must be removed again. The key is to be removed against misuse.
5.9 Equalisation of the MCS
• The MCS are adjusting automatically during lifting and lowering.
First, lower the MCS always into the lowest position, this is the prerequisite for a trouble-
free work. In this position the complete system will be reset.
To Next Page
Loading...
