Operating Instruction and Documentation
MCS 7500 Flex (Bluetooth)
- 25 -
pic 19:
7.2 Cleaning of the MCS
A regular and appropriate maintenance served the preservation of the lift.
It can be a prerequisite for claims at possible corrosion.
The best protection for the lift is the regular cleaning of dirt of all manner.
- Including this:
• de-icing salt
• sand, pebble stone, natural soil
• industrial dust of all manner
• water ; also in connection with other environmental influences
• aggressive deposit of all manner
• constant humidity by insufficient ventilation
How often must the lift be cleaned ?
This is dependent on the use, of the working with the lift, of the cleanness of the workshop and
location of the lift. The degree of the dirt is dependent on the season, of the weather conditions
and the ventilation of the workshop.
Under bad circumstances it is necessary to clean the lift every week, but a cleaning every
month can suffice.
Clean the lift and the floor with a non-aggressive and non-abrasive detergent. Use gentle
detergent to clean the parts. Use an standard washing-up liquid and lukewarm water.
- Do not use for cleaning a steam jet cleaning
- Remove all dirt careful with a sponge if necessary with a brush.
- Pay attention that are no remains of the washing-up liquids on the lift after cleaning.
- Do not use aggressive means for cleaning the workshop floor and the automotive lift.
- A permanent contact with every kind of liquid is forbidden. Do not use any high
pressure device for cleaning the lift.
To Next Page
Loading...
