EasyManua.ls Logo

Nustep T6 - Page 29

Nustep T6
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
EMC Tables
Table 2 – Guidance and MANUFACTURER’S declaration – electromagnetic IMMUNITY –
for all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturers declaration – electromagnetic immunity
The NuStep model T6 is intended for use in the electromagnetic environment specied below. The customer or
the user of the NuStep model T6 should assure that it is used in such an environment.
Immunity test
IEC 60601
Test level
Compliance level Electromagnetic environment – guidance
Electrostatic discharge
(ESD)
IEC 61000-4-2
± 6 kV contact
± 8 kV air
± 6 kV contact
± 8 kV air
Floors should be wood, concrete or ceramic tile. If oors
are covered with synthetic material, the relative humidity
should be at least 30%.
Electrical fast transient/burst
IEC 61000-4-4
± 2kV for power supply lines ± 2kV for power
supply lines
Mains power quality should be that of a typical commercial
or hospital environment.
Surge
IEC 61000-4-5
± 1 kV di󰀨erential mode
± 1 kV common mode
± 1 kV di󰀨erential
mode
± 2 kV common
mode
Mains power quality should be that of a typical commercial
or hospital environment.
Voltage dips, short
interruptions and voltage
variations on power supply
input line
IEC 61000-4-11
<5% U
T
(>95% dip in U
T
)
for 0,5 cycles
40% U
T
(60% dip in U
T
)
for 5 cycles
70% U
T
(30% dip in U
T
)
for 25 cycles
<5% U
T
(>95% dip U
T
)
for 5 sec
<5% U
T
(>95% dip in U
T
)
for 0,5 cycles
40% U
T
(60% dip in U
T
)
for 5 cycles
70% U
T
(30% dip in U
T
)
for 25 cycles
<5% U
T
(>95% dip U
T
)
for 5 sec
Mains power quality should be that of a typical
commercial or hospital environment. If the user of the
NuStep
®
T5 Recumbent Cross Trainer requires continued
operation during power mains interruptions, the NuStep
®
T5 Recumbent Cross Trainer would be powered from its
internal batteries.
Power frequency
(50/60 Hz)
Magnetic eld
IEC 61000-4-8
3 A/m 3 A/m Power frequency magnetic elds should be at levels
characteristic of a typical location in a typical commercial
or hospital environment.
NOTE U
T
is the a.c. mains voltage prior to application of the test level.

Related product manuals