32
US FCC Compliance & IEC/EN 55011 Compliance
US FCC Compliance Statement:
Note: This equipment has been tested and found to comply with the limits for a Class
B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can generate radio frequency energy and, if not
installed and used in accordance with the installation instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
may not occur in a particular installation. If the equipment causes harmful interference
to radio or television reception, which can be determined by turning this equipment o
and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit that is dierent from that to which
the receiver is connected
• Consult the dealer or an expierenced radio/TV technician for help
IEC/EN 55011 Compliance Statement:
This device complies with IEC/EN 55011, Group 1, Class B. Group 1 contains all
ISM equipment in which there is intentionally generated and/or used conductively
coupled radio-frequency energy which is necessary for the internal functioning of the
equipment itself. Class B equipment is suitable for use in domestic establishments and
in establishments directly connected to the low voltage power supply network which
supplies buildings used for domestic purposes.
Trademarks:
The Bluetooth
®
word mark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such marks by NuStep, LLC is under license. Other
trademarks and trade names are those of their respective owners.
To Next Page
Loading...
