Nustep T6 - Installation and Placement; Equipment Placement Guidelines

7
Unpacking and Installation
Unpacking and installation procedures for T6
shipments are documented in the applicable
T6 delivery installation guideline documents.
The installation guideline documents are
shipped with the products. Additional copies
of these documents are available upon
request from Customer Service.
Placement of Equipment
To ensure safe and e󰀨ective operation of
your NuStep, place on a at, stable surface.
Adjust rear leveler feet as required.
The minimum amount of required free space
around the equipment is 24 inches (61 cm)
for the sides, and 12 inches (30 cm) for
the front and rear. Additional free space
is necessary to accommodate wheelchair
access.
For added stability and oor protection, place
the recumbent cross trainer on an exercise
equipment oor mat similar to the oor mat
sold by NuStep, LLC.
Installation and Placement
75.8 in
97.0 in
12.0 in 12.0 in
24.0 in
30 cm
246 cm
30 cm
193 cm
61 cm
The T6 is very heavy; it
weighs 298 lbs (135 kg).
To avoid injury, or damage
to the product, always obtain
assistance to move this
product.
Use proper lifting technique.
CAUTION
!