Nustep T6 - Page 31

31
EMC Tables
The NuStep Recumbent Cross Trainer is intended for use in an electromagnetic environment in which radiated
RF disturbances are controlled. The customer or the user of the NuStep T6 Recumbent Cross Trainer can
help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF
communications equipment (transmitters) and the NuStep as recommended below, according to the maximum
output power of the communications equipment.
Rated maximum output
power of transmitter
W
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
d = 1,2
80 MHz to 800 MHz
d = 1,2
800 MHz to 2.5 GHz
D = 2,3
0,01 0,12 0,12 0,23
0,1 0,38 0,38 0,73
1 1,2 1,2 2,3
10 3,8 3,8 7,3
100 12 12 23
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in
metres (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the
maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is a󰀨ected by absorption
and reection from structures, objects and people.
Table 4 - Recommended separation distance between portable and mobile RF
communications equipment and the NuStep
®
T6 Recumbent Cross Trainer