NXP Semiconductors PN7160 - Page 11

NXP Semiconductors
UM11496
PN7160 evaluation board
Figure 10. OM27160 board interface connectors
J1 PN7160 signal
#1 VDD(PAD): 1.8 V or 3.3 V host interface voltage reference
#2 VDD(UP/VBAT: 2.8 V to 5.5 V supply voltage
Table 2. OM27160 board J1 connector pinout
J2 PN7160 signal
#1 I2C_SDA: I2C-bus serial data
#2 I2C_SCL: I2C-bus serial clock input
Table 3. OM27160 board J2 connector pinout (only relevant for OM27160A1HN
version)
J3 PN7160 signal
#1 Not connected
#2 GND: ground
#3 IRQ: interrupt request output
#4 VEN: reset pin
#5 DWL_REQ: download request pin
Table 4. OM27160 board J3 connector pinout
UM11496 All information provided in this document is subject to legal disclaimers. © 2022 NXP B.V. All rights reserved.
User manual Rev. 1.3 — 24 November 2022
11 / 19