NXP Semiconductors
UM11496
PN7160 evaluation board
J3 PN7160 signal
#6 Not connected
Table 4. OM27160 board J3 connector pinout...continued
J4 PN7160 signal
[1]
#1 SPI_COTI: SPI-bus Controller Output, Target Input data
#2 SPI_CITO: SPI-bus Controller Input, Target Output data
#3 SPI_NSS: SPI-bus Target Select
#4 SPI_SCK: SPI-bus Serial Clock
#5 Not connected
#6 Not connected
Table 5. OM27160 board J4 connector pinout (only relevant for OM27160B1HN
version)
[1] Updated the terms "Master/Slave" to "Controller/Target" and "MOSI/MISO" to "COTI/CITO" to align with the
recommendation of the NXP - I2C standards organization.
UM11496 All information provided in this document is subject to legal disclaimers. © 2022 NXP B.V. All rights reserved.
User manual Rev. 1.3 — 24 November 2022
12 / 19
To Next Page
Loading...
