14
STEP 3: DOWNLOAD AND DEBUG THE BSP TEST PROJECT
Select the project in Project Explorer, then right-click, choose Debug As > Debug Configuration:
In the Debug Configuration window, select the GDB PEMicro Interface Debugging > S32K148_Based_T_BOX_BSP_TestPrj_
SDK_RTM2_0_Debug>Debugger>under Interface select right debugger, and ensure Port has the right part number, then in
Additional Options, check Emergency Kinetis Device Recovery by Full Chip Erase and Use SWD protocol (if not check this
option, it will use JTAG debug protocol), at last, click Debug to launch the debug(it will download the compile result—elf file in
to the target MCU at first):
To Next Page
Loading...
