Copy jobs 17
Attention:
Strongly curled originals have to be fed in carefully. In certain
circumstances the copier can pull the original in.
[5] Feeding an original
Note:
Minimum length of the copy material is 420 mm.
5
Feed a sheet of copy material, in line with the original, into the copy feed table
in accordance with the guidelines (see figure 6 on page 18) .
Note:
The copy material is aligned in the nip of the rollers. By inserting the
material with an amount of slack, the leading edge is aligned in the nip. A delay
between insertion of the material and the start of the transport ensures proper
alignment.
To Next Page
Loading...
