Octalarm T2 User Manual

Adesys bv, Wateringen, NL
Installation instructions
Octalarm-T2 / T4 / T8 / T16
35
B
Scroll through the various menu options using the arrow keys and confirm each choice with the
enter-key.
17.1.3 Programming using a telephone line
17.1.3.1 Analogue or ISDN model
Remote programming is possible using the built-in modem of the Octalarm on 2.400 baud (V.22bis).
After establishing the connection, the programming menu of the Octalarm appears. Scroll through the
various menu options using the arrow keys and confirm each choice with the enter-key.
The Octalarm disposes of two ways to establish a modem connection:
•
Call the Octalarm using a telephone and enter the following code (during the short beeps):
“# 9 #
requisite access code ##".
Put the telephone down. Call the Octalarm from a PC with a modem
within one minute.
•
Call the Octalarm using a telephone and enter the following code (during the short beeps):
“# 9 #
requisite access code # telephone number to call back #".
Put the receiver down. The Octalarm
will call the number entered immediately and will expect a modem to be available.

Programming by telephone is only possible if the function has been made available
beforehand in prog. 61, “setting access code”. Remote programming is not possible without an
access code.

If the Octalarm has been set so that the alarm status is first transmitted by telephone, it will
take longer before the modem connects. Take this into account when setting up the
transmitting modem. It may be necessary to increase the waiting time for the carrier. Most
modems use the command ATS7= ... for this.
17.1.3.2 GSM model
The inbuilt GSM modem allows communication with modems on the analogue network, for remote
programming. Set the analogue modem in the PC to 9.600bd. Other speeds may be possible,
depending on the network operator. A data supplement to the GSM subscription should not be
necessary.
Call the Octalarm using a telephone and enter the following code (during the short beeps):
“# 9 #
requisite access code # telephone number to call back #".
Put the receiver down. The Octalarm will
call the number entered immediately and will expect a modem to be available.
Once the connection has been made, the Octalarm’s programming menu will appear. Use the arrow
keys to go through the various options, and confirm each choice with the Enter key.

Programming by telephone is only possible if the function has been made available
beforehand in prog. 61, “setting access code”. Remote programming is not possible without an
access code.

Octalarm T2 Specifications

General

Brand	Octalarm
Model	T2
Category	Security System
Language	English