13 Test measurement with the Pentacam® AXL
Instruction Manual Pentacam® AXL (G/70100/EN 1121 Rev04) 61 / 85
Exclude all possible reasons (see screen) for a fail test measurement.
Repeat the test measurement again. If also this test measurement is
not successfull please call your authorized dealer.
To finish this process click "OK".
In case you had to replace the test eye because of any reason you have to
type in the axial length of the new test eye into the input field before you
do a new test measurement.
After the test measurement process is finished you can slide down the
test eye.
Fig. 13-3: Sliding down the test eye
To Next Page
Loading...
Need help?
General
