20 Annex
76 / 85 Instruction Manual Pentacam® AXL (G/70100/EN 1121 Rev04)
To be in compliance with the requirements of the IEC 60601-1-2. 6.1 and
6.2 the following types of equipment, accessories, power adapters and
cables must be used.
20.2 Guidance and Manufacturer’s Declaration - Electromagnetic
Emisssions for the Pentacam® AXL
Order number Description
70100 Pentacam® AXL
05200320 Cable with connector
plug, EU standard
2.5 m (98.4 in)
05200210
(110 Volt)
Cable with connector
plug, US standard
2.5 m (98.4 in)
05150150 Power adapter HMEG 49 24 V, 2,1A
70002 Y cable with galvanic
isolation
2 m
Guidance and manufacturer´s declaration electromagentic emissions
IEC 60601-1-2, 5.2.2.1, table 1
The OCULUS Pentacam® AXL is intended for operation in the electromagnetic environment specified below. The
user of the Pentacam® AXL should ensure that it is being used in such an environment.
Emissions test Compliance Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1 The Pentacam® AXL uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment.
HF-emissions
CISPR 11
Class B
Harmonics emissions
IEC 61000-3-2
Class A
Voltage fluctuations /
flicker emissions
IEC 61000-3-3
complies
To Next Page
Loading...
