Engine oil level verification
Strictly following this procedure, otherwise
wrong oil level may be indicated.
1. Ensure vehicle is on a level surface.
2. Start engine and let idle for a few minutes.
3. Stop engine. Wait a few minutes to allow oil
to flow down to crankcase then check oil
level.
4. Remove left and right seats, gear shift
handle.
5. Remove engine shield
6. Remove dipstick and wipe clean stem.
7. Fully screw in dipstick to check oil level.
8. Remove dipstick and read oil level. Oil level
must be between minimum (2) and
maximum (1) marks on dipstick.
9. There is a capacity of 300 ml between
the two marks. Refill oil as necessary.
Do not overfill.
10. Re-install dipstick.
To Next Page
Loading...