5. Connect the negative lead of the jumper
cable to the negative terminal of the
negative lead to an unpainted metal
surface of the vehicle.
Do not connect the negative lead of the
jumper cable to the negative terminal of the
battery in the vehicle.
● Be especially careful not to touch the
positive lead of the jumper cable to the
negative lead or not to reverse the polarity
of the jumper cables when connecting to
the batteries-battery, explosion and/or
serious damage to the electrical system
may occur.
6. Start the engine.
7. After the engine starts, disconnect the
negative lead of the jumper cable from
the vehicle and charged battery, then
disconnect the positive lead of the jumper
cable from the charged battery and the
battery in the vehicle.
8. Install the battery compartment cover.
9. Close the hood.
Warming up
To get maximum engine life, always warm
up the engine before starting off. Never
accelerate hard with a cold engine! To see
whether or not the engine idles smoothly.
Drive select lever operation
and reverse driving
CAUTION：
To Next Page
Loading...