To wear the seat belt properly, do the
following:
1. Hold the latch plate as you pull the belt
across your lap and chest. Make sure the
belt is not twisted and is not caught on
any portion of the vehicle, your clothing,
or any equipment you are carrying.
2. Push the latch plate into the buckle until it
clicks. Pull up on the latch plate to make
sure it is secure.
1. Buckle 2. Latch plate
3. Put the lap portion of the belt low on your
hips. Push down on the buckle end of the
belt as you pull up on the shoulder part so
the belt is snug across your hips.
4. Position the shoulder belt over your
shoulder and across your chest. The
shoulder belt should fit against your chest.
If it is loose, pull the belt out all the way
and then let it retract.
5. To release the buckle, firmly press the
release button.
1. Buckle 2. Release button.
To Next Page
Loading...