Remove access panel.
1. Coolant reservoir
With vehicle on a level surface, liquid
should be between MIN and MAX
marked on the coolant reservoir.
NOTE: When checking level at
temperature lower than 20℃,it may be
slightly lower than MIN mark. Add
coolant up to MAX mark if required.
Use a funnel to avoid spillage. Do not
overfill.
Properly reinstall and tighten filler cap
and reinstall access panel. If coolant is
added in the coolant reservoir, check
the radiator level too. Add coolant if
necessary.
WARNING
In order to avoid getting
burned, do not remove the
radiator cap if the engine is
hot.
NOTE: A cooling system that frequently
requires coolant is the indication of
leaks or engine problems. See an
authorized dealer.
Coolant Replacement
In order to avoid potential
burns, do not remove the
radiator cap or loosen the
coolant drain plug if the engine
is hot.
To Next Page
Loading...
Need help?
General