What to do if OHAUS Scout SKX show Err 8.3?
If your OHAUS Scales display 'Err 8.3', it indicates an overload situation where the weight exceeds the rated capacity. To resolve this, reduce the weight on the scale to stay within its specified limits.
What does Err 8.1 mean on OHAUS Scout SKX and how to fix it?
If your OHAUS Scales show 'Err 8.1', this means the weight exceeds the power on zero range. Remove the excess weight to fix this issue.
What does Err 8.2 mean on OHAUS Scales?
If your OHAUS Scales are showing 'Err 8.2', it means the weight is below the power on zero range. You should add weight to correct this.
What to do if OHAUS Scout SKX display Err 8.4?
If your OHAUS Scales show 'Err 8.4', it means there is an under load condition, usually because the pan has been removed. Make sure to place the pan back on the scale.
Why are my OHAUS Scout SKX showing poor accuracy?
If your OHAUS Scales are not providing accurate measurements, it might be due to improper calibration or an unstable environment. Recalibrate the scale and ensure the environment is stable.
What does CAL E mean on OHAUS Scout SKX Scales?
If your OHAUS Scales display 'CAL E', it means the calibration process has failed. Try to calibrate the scales again.
What does Err 8.5 mean on OHAUS Scout SKX?
If your OHAUS Scales display 'Err 8.5', it indicates that the tare setting is out of range. Review and adjust the tare settings accordingly.
What does error Err 8.6 mean on OHAUS Scout SKX Scales?
If your OHAUS Scales display 'Err 8.6', the displayed value has exceeded 999999, which can occur in Totalization mode. Reset the totalization to resolve this.
What does ref.err mean on OHAUS Scout SKX?
If your OHAUS Scales show 'ref.err', it means there is a parts counting or percentage error because the sample weight is less than 1d. Ensure the sample weight is adequate.
What does Lo.ref mean on OHAUS Scout SKX?
If your OHAUS Scales display 'Lo.ref', it means the Percent Reference weight or APW is too low for accurate results. Increase the reference weight to fix this.
General| Display | LCD with backlight |
|---|---|
| Calibration | External calibration |
| Legal for Trade | No |
| Auto-Off | Yes |
| Power Supply | AC adapter or 4 AA batteries (optional) |
| Operating Temperature | 10°C to 40°C |
| Units of Measurement | g, oz, ozt, dwt, ct, gn, tl, N |
| Stabilization Time | 1.5 seconds |
| Interface | USB (optional) |
To Next Page
