To Next Page
S
Stacey CalderonSep 6, 2025
What is EEP Error on OHAUS Accessories?
- SsmithheatherSep 6, 2025
The EEP Error on OHAUS Accessories indicates a corrupted EEPROM data.
What is EEP Error on OHAUS Accessories?
The EEP Error on OHAUS Accessories indicates a corrupted EEPROM data.
What does NO.SW mean on my OHAUS Accessories?
If your OHAUS Accessories displays ‘NO.SW’, it means you are attempting to exit the menu with the LFT setting ON and the security switch OFF. Set the security switch to the ON position.
What does REF WT Err mean on my OHAUS Accessories?
If your OHAUS Accessories displays ‘REF WT Err’, the reference weight is too small. Use a greater weight for the sample.
What to do if my OHAUS Accessories unit will not turn on?
If the OHAUS Accessories unit does not turn on, first check the power cord connections to ensure it is properly plugged into both the unit and a functioning power outlet. Verify the power source is supplying electricity. If using a T52P model, the batteries may be discharged and need replacement. If these steps don't resolve the issue, service is required.
What does it mean when the battery symbol is flashing on my OHAUS Accessories?
If the battery symbol is flashing on your OHAUS Accessories (T52P), it indicates that the batteries are discharged and need to be replaced.
How to change menu settings on my OHAUS Accessories?
If you cannot change menu settings on your OHAUS Accessories, it is likely that the menu has been locked. To unlock it, set the selected menu to Off in the Lock Menu. Additionally, the Lockout Switch on the circuit board may need to be set to the Off position.
How to display weight in the desired weighing unit on my OHAUS Accessories?
If your OHAUS Accessories cannot display weight in the desired weighing unit, the unit may not be set to On in the Units Menu. Enable the unit in the Units Menu.
What to do if my OHAUS Accessories scale cannot zero?
If the OHAUS Accessories scale cannot zero, or will not zero when turned on, it may be due to the load on the scale exceeding allowable limits, the load not being stable, or load cell damage. Remove the load from the scale and wait for it to become stable. If the problem persists, service is required.
Why am I unable to calibrate my OHAUS Accessories?
If you are unable to calibrate your OHAUS Accessories, it might be because the Lock Calibration Menu is set to On, or the LFT menu is set to On, or you are using an incorrect value for the calibration mass. Set the Lock Calibration Menu to Off and the LFT menu to Off. Ensure you are using the correct calibration mass.
What to do if my OHAUS Accessories shows Error 9.5?
If the OHAUS Accessories scale displays Error 9.5, it indicates that calibration data is not present. You should calibrate the scale.
General| Display | LCD |
|---|---|
| Protection | IP54 |
| Legal for Trade | Yes |
| Calibration | External Calibration |
| Power Supply | AC Adapter |
| Dimensions | 300 x 300 x 120 mm |
| Communication | RS232 |
| Operating Temperature | 0 to 40 °C |
| Relative Humidity | 10% to 85% non-condensing |
