The RCD is reset by power cycling the unit or by unplugging and plugging the charger
from the vehicle.
No overcurrent protection is provided in the Ohme Charger, separate provision must be
provided as part of the installation. A mounting screw kit is provided to securely attach
the charger to a wall or post.
The Ohme Home charger is a single-phase device with three input connections:
The input lead is one metre long and the conductors are 6mm
2
copper. They need to be
terminated to a suitable junction box or similar (not supplied).
Ohme Go Installation
The Ohme Go charger comes in four power input connector types:
• 32A Commando plug (IEC 60309)
• Type 2 (IEC 62196)
• Schuko / European Plug
• UK 3-Pin plug (BS 1363)
As with all EV charging equipment, we recommend that the RCD in your property is
checked. Type AC RCDs should not be used with an EV charger.
We recommend that the electrical installation is checked by a qualied/competent
electrician for safety. EV charging is more demanding on your system than normal
appliances.
To Next Page
Loading...
