OJ Electronics UWG4 User Manual

PAGE 59
© 2015 OJ Electronics A/S
10.4.6 Room Sensor Calibration
This option allows you to calibrate the room sensor.
You can calibrate the sensor if the temperature reading diers from the actual room
temperature.
Note that changes in room sensor characteristics may damage certain floors.
You can calibrate the sensor with ±17°F or ±10°C in steps of 1°F or 0.5°C in the
following way:
1. Tap the “Menu” button on the home screen.
2. Then tap the “Installer Settings” button to access the various installer settings.
3. Tap the “Room Sensor Calibration” button.
4. Use the “Arrow Up” or “Arrow Down” button to set the room temperature
actually measured.
5. Confirm that you want to calibrate the sensor with “√” or cancel with “X”.
If the temperature is confirmed with “√”, a confirmation screen will be displayed
briefly.
The thermostat will automatically return to “Installer Settings”.

OJ Electronics UWG4 Specifications

General

Type	Wireless Thermostat
Compatibility	Underfloor heating systems
Protection Class	IP21
Display	LCD
Mounting	Wall-mounted
Output	Relay output
Temperature Range	5°C to 45°C
Switching Voltage	230V AC
Operating Temperature Range	0°C to 40°C
Storage Temperature Range	-20°C to 60°C
Wireless Range	Up to 30m
Operating modes	Manual
Dimensions	86 x 86 x 20 mm