OJ Electronics UWG4 - Screen Indicator Issues; Slow Floor Warming Issues

PAGE 70
© 2015 OJ Electronics A/S
12. Troubleshooting 2/5
•Acirclecontainingadotisdisplayedintheupperleftcornerofthescreenandthe
following text is displayed:
“Press on the filled circle”.
Pressure has probably been applied to the screen while power was connected or
the thermostat was turned on. Restart the thermostat in the following way to con-
tinue using it:
1. Hold the power/reset button on the right side of the thermostat to switch it o.
2. Press the power/reset button on the right side of the thermostat to turn it back
on.
The thermostat will then boot normally.
•Theooriswarmingup,butmoreslowlythanexpected.
- Floor protection might be set to “Laminate”, which prevents rapid heating of the
floor.
- The heating element might have insucient capacity to heat the floor.