Oki B430

4. ADJUSTMENT
43984801TH Rev.1
80 /
Oki Data CONFIDENTIAL
• Engine maintenance mode menu chart
-16
LED HEAD LED HEAD -15
0 *
~
-1
0
1
~
15
STRB TIM STRB TIM 0.50
0.50 * 0.54
0.42
0.46
OPT HEAD OPT HEAD ODD/EVN
ODD/EVN * STEP3
PRINTPOS PRINTPOS 0 mm
0 mm * +0.5mm
~
+3.5mm
-4.0mm
~
-0.5mm
LENSHIFT LENSHIFT 0 mm
0 mm * +0.5mm
~
+3.5mm
-4.0mm
~
-0.5mm
DRUM CNT
T nnnnnn
DRUM CNT
nnnnnn
PAGE CNT
nnnnnn
DOT CNT
T nnnnnn
DOT CNT
nnnnnn
T1 POS T1 POS 0 mm
0 mm * +1 mm
~
+7 mm
-8 mm
~
-1 mm
T2 POS T2 POS 0 mm
0 mm * +1 mm
~
+7 mm
-8 mm
~
-1 mm
う。
Press Key
“SETTING”
Press Key
“SETTING”
Press Key
“SETTING”
Press Key
“SETTING”
Press Key
“SETTING”
Press Key
“SETTING”
Press Key “MENU▲” “MENU▼”
and move
Select by
Key “SETTING”
and press key
“MENU▲”
“MENU▼”
Select by
Key “SETTING”
and press key
“MENU▲”
“MENU▼”
Select by
Key “SETTING”
and press key
“MENU▲”
“MENU▼”
Select by
Key “SETTING”
and press key
“MENU▲”
“MENU▼”
Select by
Key “SETTING”
and press key
“MENU▲”
“MENU▼”
Select by
Key “SETTING”
and press key
“MENU▲”
“MENU▼”
Press Key
“SETTING”
Select by
Key “SETTING”
and press key
“MENU▲”
“MENU▼”
“Display Indicating”
Set the drive time of ED Head.
Set by the relative value between the strobe
time of 600 x 1200DPI and the strobe time of
600 x 600.
In this printer, this setting is not used.
Set the start position of printing.
Set the offset of picture elastic (The minor
adjustment. of LSYNC cycle).
Drum Count Total Display
Display it on LCD about the total drum-rotating
count that is counted by the engine part.
Drum Count Display
Display it on LCD about the drum-rotating count
from drum replacement that is counted by the
engine part.
Page Count Display
Display it on LCD about the total printing page
count that is counted by the engine part.
Page DotCount Display
Display it on LCD about the printing DotCount
that is counted by the engine part.
Page Count Total Display
Display the DotCount from the new toner
cartridge installed till now.
Set Paper-feeding amount that is from the
standard tray.
(Paper striking amount setting)
Set Paper-feeding amount that is from the
second tray.
(Paper striking amount setting)