B6500 Network Guide> 28
I
NTERFACE
The printer LPD is available on the following interfaces:
• Ethernet 100BaseTX
• Ethernet 10Base-T
The applicable frame types conform to Ethernet II.
S
ET
U
P
P
ROCEDURE
The setting procedure is as follows:
1. Setting up the printer
Set the IP address on the printer control panel.
Use the printer control panel or printer web page to set the
LPD port to [Enable] (default: [Enable]).
NOTE
> Before activating the LPD port, set the IP address of the
printer. For details on how to set the IP address and the
port, refer Printer Configuration.
> The printer web page allows more detailed settings.
2. Settings of the workstation
Set the printer in the workstation.
Refer to:
“Setting Up the Workstation” on page 29
To Next Page
Loading...
