Oki B6500

B6500 Network Guide> 61
A PPENDIX A: S ETTING IP A DDRESS
1. Press the <MENU> button to display the Menu screen.
2. Press the <S> or <T> button until [Network Menu] is
displayed, then press the <X> button.
3. Check that [TCP/IP] is displayed, then press the <X> button.
4. Press the <S> or <T> button until TCP/IP is set for
[Enable], then press the <SELECT> button.
5. Press the <S> or <T> button until [IP Address Set] is
displayed, then press the <X> button.
6. Press the <S> or <T> button until [Manual] is displayed,
then press the <SELECT> button.
7. Press the <S> or <T> button until [IP Address] is
displayed, then press the <X> button.
8. The first set of numbers of the IP address will blink. Press the
<S> or <T> button to scroll to the desired number.
9. Press the <X> button to save the current set of numbers and
move to the next set.
10. Repeat steps 8 and 9 until all numbers have been set, then
press the <SELECT> button.
11. Press the <S> or <T> button until [Subnet Mask] is
displayed, then press the <X> button.
12. The first set of numbers of the Subnet Mask will blink. Press
the <S> or <T> button to scroll to the desired number.
13. Press the <X> button to save the current set of numbers and
move to the next set.
14. Repeat steps 12 and 13 until all numbers have been set, then
press the <SELECT> button.
15. Repeat steps 11, 12, 13, & 14 to set the Gateway Address as
necessary.
16. Press the <CANCEL>
button. To exit the menus.
17. Reboot the printer.