B6500 Network Guide> 37
NOTE
> If several parameters are specified in one "lpr" command,
data may not be printed correctly.
> The system default is used if no tray number is specified,
a specified tray is not loaded, or paper of a specified size
is not loaded.
> This option is for specifying a paper size only. Paper is
selected but the document size is not corrected according
to the paper size.
> If the print data specifies a paper tray, the tray
specification by the data becomes valid and that by the -C
option becomes invalid.
> If an unacceptable combination is specified, the printer
may not operate correctly.
> For some print language, the specification may be invalid.
Selecting a Paper Output Tray
The following parameters can be specified:
Selecting a Paper Type
The following parameters can be specified:
PARAMETER DESCRIPTION
OUTUP/outup Ejects prints to the rear tray (option).
OUTDOWN/outdown Ejects prints to the center tray.
PARAMETER DESCRIPTION
PTS/pts Selects Plain paper.
PT1/pt1 Selects Heavy weight paper 1.
PT2/pt2 Selects Heavy weight paper 2.
POH/poh Selects Transparency.
PRC/prc Selects Recycled paper.
To Next Page
Loading...
