B930n User’s Guide> 112
9. Lift the printer and move it gently. If the printer is to be
moved over a long distance, pack it inside a box.
F
USER
U
NIT
This section explains the Fuser unit replacement.
C
AUTION
ON
H
ANDLING
THE
F
USER
U
NIT
The fuser unit is included as one of the regular replacement parts.
Before replacing the fuser unit, open the box of the regular
replacement parts and get the new fuser unit ready.
When handling the fuser unit, take note of the following
CAUTION
> Never touch a labelled area found on or near the heat
roller. You can get burned. If a sheet of paper is
wrapped around the heat roller, do not try to remove it
by yourself to avoid injuries or burns. Switch off the
machine immediately, and contact your service
provider. Be sure to switch off and unplug the machine
before accessing the interior of the machine for
cleaning, maintenance, or fault clearance. Access to a
live machine’s interior can cause electric shock.
R
EPLACING
THE
F
USER
U
NIT
1. Switch off the power of the printer and leave it for 30
minutes until the fuser unit cools down.
To Next Page
Loading...
Need help?
General
